V2ray Mikrotik Today

/container log 0

Force all DNS requests to go through the proxy by redirecting UDP port 53.

Administrative access to the WinBox interface or RouterOS CLI.

For security reasons, MikroTik requires physical access or a cold boot to enable container features. Open the MikroTik terminal and run: /system/device-mode/update container=yes Use code with caution. v2ray mikrotik

Comprehensive Guide to Configuring V2Ray on MikroTik RouterOS

MikroTik’s FastTrack bypasses the firewall mangle chain to save CPU cycles. You must add an exception rule above your FastTrack rule to ensure marked V2Ray traffic gets processed correctly.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. /container log 0 Force all DNS requests to

: Ensure that the V2Ray gateway machine itself is not included in the Proxy_Devices firewall address list. If it is, it will attempt to route its own encrypted outbound traffic back into itself, causing an immediate crash.

/ip firewall nat add chain=dstnat protocol=udp dst-port=53 action=dst-nat to-addresses=192.168.88.10

"outbounds": [

]

Start it:

Unlike Socks or HTTP proxy, TPROXY preserves the original destination IP. This means CDNs, banking apps, and gaming traffic work flawlessly. This public link is valid for 7 days

Before touching the terminal, understand the layers. V2Ray typically listens on a or HTTP proxy port (e.g., 1080) or uses transparent proxy (TPROXY). MikroTik does not natively speak VMess or VLESS.