Qidi X-pro Manual [ iOS PREMIUM ]

Please let me know if you want me to add or modify anything!

Select your target temperature based on the material (e.g., 200°C for PLA) and choose the or Right extruder. Wait for the nozzle to reach the target temperature. Cut the tip of the filament at a 45-degree angle.

Wait for the printer to home its X, Y, and Z axes. The nozzles will move to the first leveling point.

is a fully enclosed FDM printer designed for stability and high precision. qidi x-pro manual

Connect the power cord to the back of the printer and plug it into a grounded outlet. Flip the power switch to the position.

If filament stops extruding, heat the nozzle to 240°C. Use the included unclogging pin to push through the top of the extruder drive down through the nozzle tip to clear debris.

The QIDI X-Pro uses , which is based on the popular Cura slicing engine. You can also use standard Cura or Simplify3D. First-Time Slicer Setup Please let me know if you want me to add or modify anything

The QIDI X-Pro comes mostly assembled, but a few critical components require manual installation before turning the machine on. Mounting the Extruder Assembly Locate the X-axis carriage inside the printer. Place the dual extruder assembly onto the carriage bracket.

Print not sticking to bed.

Insert the two metal spool holders into the slots located on the back panel of the printer. Secure them using the provided thumbscrews. Cut the tip of the filament at a 45-degree angle

The X-Pro relies on a manual three-point leveling system. Perfect bed leveling is the single most critical factor for achieving proper first-layer adhesion. [Back Center Knob] O O O [Front Left] [Front Right] The Leveling Process

Adjust the thumb nut under the front-left corner of the bed until you feel a slight resistance/friction when moving the paper.

Select the Tools icon, then Leveling . Follow the on-screen prompts. You’ll want a standard piece of A4 paper to slide between the nozzle and the bed with just a slight "drag". Loading Filament: Heat the extruder(s) via the Preheat menu.