Fagor Fi-80 Dishwasher Manual Page

Allow the dishwasher 20 to 30 minutes to heat up. Do not run a cycle until the wash tank reaches at least 150°F (66°C) and the booster tank reaches 180°F (82°C).

If the error persists after a basic check, a soft reset can be attempted by turning off the appliance, unplugging it for at least 60 seconds, and then restarting. fagor fi-80 dishwasher manual

⚠️ Electrical wiring must be performed by a licensed electrician in accordance with local national electrical codes (NEC). Allow the dishwasher 20 to 30 minutes to heat up

Choose the desired wash time (e.g., P1 for 1 minute or other preset intervals). Parts Town Installation Requirements Water Supply: Requires a dynamic pressure between (approx. 28-56 psi). If pressure is below 2 , a pressure pump must be installed. Water Hardness: If the local water supply is above ⚠️ Electrical wiring must be performed by a

Located inside the lower front utility compartment. Adjust the screw clockwise to increase chemical intake or counterclockwise to decrease it. Target a concentration recommended by your chemical supplier based on local water hardness.

| Code | Description | Likely Cause | Solution | | :--- | :--- | :--- | :--- | | | Water inlet fault | Low water pressure, closed tap, or faulty inlet valve | Check water supply and clean inlet filter. | | F2 | Drain error | Blocked or kinked drain hose | Clear drain hose and check pump filter. | | F3 | Heating error | Faulty heating element or thermostat | May require a technician or a new 4.5 KW resistor. | | F4 | Overflow | Water leakage into base tray | Inspect door seals and drain system. | | F5 | Door lock error | Hood not closed properly or faulty latch sensor | Check door alignment and magnetic switch. | | F9 | Motor error | Motor or alternating current issue | Professional inspection advised. |

Run the machine through 3 to 4 consecutive cycles without any dishes loaded.