Refer to this section of the Gateman V20 manual for common issues:
: To prevent fingerprint smudges from revealing your code, you can touch the keypad with your palm before or after entering your PIN. Automatic/Manual Locking
: It requires 4 AA alkaline batteries. Always replace all four at once to avoid leakage.
Hold your first key tag against the card reader icon. A chime will sound. gateman v20 manual
The lock sensor detects when the door is closed and automatically throws the deadbolt after a 2-second delay.
: There is typically a 0-1-2 switch inside the battery compartment to set the volume to Mute, Low, or High.
: Approximately 1.5 years based on 10 uses per day. Refer to this section of the Gateman V20
Press and hold the 9V battery terminals firmly against these contact points.
The GateMan V20 package includes:
Close the door, and the lock will automatically engage. Manual Mode: Touch the screen with your palm to lock. Hold your first key tag against the card reader icon
Open the battery cover on the inner body and press the or [R] button once.
Walk to the outside keypad and enter your desired . Press the [*] (Star) key to complete the registration. Test the new code with the door open before closing it. How to Register a Smart Key / RFID Card
Press the . All stored RFID credentials are now wiped from memory. 5. Daily Operation Unlocking from the Outside
Touch the keypad with your palm to activate it. Enter your registered PIN code, then touch the keypad again with your palm (or press the [#] button).